Data Acquisition:

The aerial photography for this project was captured within the 2014/15 flying season (September

2014 – April 2015) on 10, 25, 26 October 2014, 09, 10, 11 November 2014, 04 January 2015, 03, 04 May 2015.

All photography was captured using Vexcel's digital UCLp and UCE cameras with flying height of UCLp 3829ft and UCE 6312ft.

Data Processing:

All aspects of the data processing from imagery processing to DTM creation and ortho production

and product deliverables was undertaken in-house by Aerial Surveys and Cyient staff.

Map Projection:

All spatial data for this project provided in terms of New Zealand Transverse Mercator (NZTM) map

projection. The datum is New Zealand Geodetic Datum 2000. The height datum is orthometric One

Tree Point 1946 (sea level).

Image Processing and Aerial Triangulation:

All imagery has gone through QA checks ensuring there is no cloud cover and cloud shadow. During

aerial acquisition the aircraft on-board GPS navigation data and ground base station data collected

and post processed. Imagery processed to level 3 and checked for colour correctness/radiometry and

even tonal balance across each project area. The aerial triangulation brings together the GPS data

and imagery using a two part process which stitches the imagery together using tie point matching

for the relative orientation phase and observing ground control points for the absolute orientation

phase. LINZ control, 8th order horizontal and 4th order vertical and other existing control from Aerial

Surveys control data base were used to strengthen the block adjustment or as independent checks on position during final QA of the ortho imagery. A final report is generated to check RMSE values are

within specification.

DTM Creation:

The DTM creation for the urban areas was collected from stereo imagery using photogrammetric

techniques, largely automated pixel matching and auto-correlation process that creates mass points

of the terrain surface with further manual editing to remove points on water bodies and extensive

breaklines added around water bodies and along all ridges, valleys and areas of steep terrain change,

such as kerbs, retaining walls, drains. In areas of dense vegetation form lines are collected. The final

DTM took the form of breaklines and mass points. A Triangulated Irregular Network (TIN) was then

created and used for the ortho-rectification process.

DTM Accuracy: ±0.2m @ 95% confidence level in clear open areas (2 sigma)

RGB and Ortho Rectification Process: Ortho rectification is the process of removing (from the image) the effects of camera tip/tilt and displacement caused by terrain relief. During this process each frame is 'draped' over the terrain model and the photograph then becomes 'scaled' and 'levelled' in terms of true ground coordinates. The generation of seamlines between frames follow natural physical features such as ridges, valleys, roads and rivers. The seamlines are used for the final ortho mosaic that stitches the imagery together using feather mosaicking techniques. The ortho imagery is then extracted aligned to LINZ 1:500 sheet tile layout.