Data Acquisition:

Airborne Laser Scanner (ALS) data was acquired from a fixed wing aircraft on 9 November and 21 November 2016, using Aerial Surveys Optech Orion H300 LiDAR system.

Survey Specification:

- Scanner: Optech Orion H300

- Flying Height: 1475 m AMGL

- Scan Angle: ± 20 degrees

- Scan Frequency: 45.0Hz

- Pulse Rate: 1750kHz

- Swath Overlap: 30%

- Points Per M2: 2.00

Data Processing:

The LiDAR sensor positioning and orientation (POS) was determined using the collected GPS/IMU datasets and Applanix POSPac software.

Benchmarks:

WHNG owned by LINZ

Base Station Positions:

-36 48 13.577724 S 174 18 52.4394 E 172.775 Ell Height

Antenna Height:

0.085 Phase Center

The POS data was combined with the LiDAR range files and used to generate LIDAR point clouds in NZTM and ellipsoidal heights. This process was undertaken using Optech LMS LiDAR processing software. The data was checked for completeness of coverage. The relative fit of data in the overlap between strips was also checked.

The height accuracy of the ground classified LiDAR points was checked using open land-cover survey check site data collected by Sounds Surveying Ltd. This was done by calculating height differences statistics between a TIN of the LiDAR ground points and the checkpoints. The standard deviation statistic is 0.030 m; a RMS of 0.037 m and the average difference is -0.021 m.

The positional accuracy of the LiDAR data has been checked by overlaying Sounds Surveying Ltd surveyed data over the LiDAR data displayed coded by intensity. The data was found to fit well in position.

The point cloud data was then classified with TerraSolid LiDAR processing software into ground and above ground returns using automated routines tailored to the project landcover and terrain.

All product deliverables supplied in terms of NZTM map projection and NZVD2016 height datum.

Classification of the point cloud followed the classification scheme below:

1 - Unclassified

2 - Ground

Above_Ground (14) points was reclassified by LINZ as Unassigned classification (1) before providing the classified point cloud data to Open Topography.

Lakes were hydroflattened in the Bare Earth Digital Elevation Model.

The deliverables to LINZ were:

1m gridded bare earth digital elevation model (DEM)

1m gridded digital surface model (DSM)

Classified point cloud